MIG welding of aluminum is one of the most difficult to weld. This is a great demand for aluminum welders in the shipyard, but unfortunately there is little training to teach the proper techniques of MIG welding are used for this type of work. MIG welding of aluminum are usually the thickness of the material, the setting of a higher voltage and high speed is relative. For most applications, are the voltage control 19 to 23 volts. Choice of shielding gas 100% Argon and almost never changed. This type of press-welding is a bed made available. Stringer accounts excluded only if it is the most critical solder joints.
When it comes to the configuration of the machine, the wire speed is in most cases. The ideal arrangement would produce noise, rattling fast, even if this type of spray arc. That the wire feed speed is fast enough to keep the pressure in the weld wire partner, without the arc length of the construction. The machine is the most important part of the MIG welding of aluminum, because if the computer is configured, then it is adjusted to very little.
The technique used is always the next round with the gun angle slightly oblique to the direction of travel. To begin weld, about 1/4 inch away from the starting point and start again at the bow ready, go back to where you want to start weld. This is done by a welder to have time for some early heat and allow good penetration. Usually begins after soldering, there are two techniques. Beaten back and forth movement and weaving a little. The problem with the MIG welding of aluminum is that the speed is very fast and you need to stay ahead of the pond. MIG welding of aluminum is really the kind of sweat production, which means getting back into welding technology for speedy travel, no matter how fast they are used. Remember to stay in front of the pond and not slowly.
When it comes to the configuration of the machine, the wire speed is in most cases. The ideal arrangement would produce noise, rattling fast, even if this type of spray arc. That the wire feed speed is fast enough to keep the pressure in the weld wire partner, without the arc length of the construction. The machine is the most important part of the MIG welding of aluminum, because if the computer is configured, then it is adjusted to very little.
The technique used is always the next round with the gun angle slightly oblique to the direction of travel. To begin weld, about 1/4 inch away from the starting point and start again at the bow ready, go back to where you want to start weld. This is done by a welder to have time for some early heat and allow good penetration. Usually begins after soldering, there are two techniques. Beaten back and forth movement and weaving a little. The problem with the MIG welding of aluminum is that the speed is very fast and you need to stay ahead of the pond. MIG welding of aluminum is really the kind of sweat production, which means getting back into welding technology for speedy travel, no matter how fast they are used. Remember to stay in front of the pond and not slowly.
Tidak ada komentar:
Posting Komentar