Mig welding aluminum can be a real pain for many people. For you to weld aluminum nicely with a mig welder you must first set it up to run the wires gently. The biggest problem when using a wire allies is that it is very soft. Because the wire is so soft, people always run to the wire feeding problems. To succeed you must have a weld aluminum mig welding guns are very fine eating.
To start welding is not going to use very long cables. Ideally, try to remain at about 10 feet long, which is about 3m. The longer distance is that the wire has to travel through a welding gun is more resistance there will be internal. You also need to use a plastic or teflon liner. These liners provide much less resistance than the steel ship your standard mig welding torch. Some welding torch will also require you to replace the liner in the torch neck as well.
The next item that you need to change to be able to successfully weld aluminum or feed roll drive. Standard roll feed will come with av shaped groove in it. But to have a softer aluminum wire feed rolls have a special U-shaped pattern Specific pattern allows more surface contact area that has been more compelled to feed the wire through the gun. Standard contact tip size to up to a larger size to allow for easier wire feed. Ideally, if your computer has four-wheel drive on the feed wire as opposed to two wheels, you will have more traction and power feed wire. You can also buy a so-called push-pull mig welding gun.
It is designed specifically for this type of application and will offer 100% wire feed capability and reliability. The way that this work is that they have a set of feed rollers are built to handle the torch. So now the wire just to feed roughly about a foot from the bait to where this roller is arc welding. You also have to clean all the surfaces with stainless steel wire brush. This brush should only be used on aluminum and never on anything else, period. If you use it for something else and then come back to use it on your allies will end up polluting everything. Then when you go to weld again it would not be enough.
To start welding is not going to use very long cables. Ideally, try to remain at about 10 feet long, which is about 3m. The longer distance is that the wire has to travel through a welding gun is more resistance there will be internal. You also need to use a plastic or teflon liner. These liners provide much less resistance than the steel ship your standard mig welding torch. Some welding torch will also require you to replace the liner in the torch neck as well.
The next item that you need to change to be able to successfully weld aluminum or feed roll drive. Standard roll feed will come with av shaped groove in it. But to have a softer aluminum wire feed rolls have a special U-shaped pattern Specific pattern allows more surface contact area that has been more compelled to feed the wire through the gun. Standard contact tip size to up to a larger size to allow for easier wire feed. Ideally, if your computer has four-wheel drive on the feed wire as opposed to two wheels, you will have more traction and power feed wire. You can also buy a so-called push-pull mig welding gun.
It is designed specifically for this type of application and will offer 100% wire feed capability and reliability. The way that this work is that they have a set of feed rollers are built to handle the torch. So now the wire just to feed roughly about a foot from the bait to where this roller is arc welding. You also have to clean all the surfaces with stainless steel wire brush. This brush should only be used on aluminum and never on anything else, period. If you use it for something else and then come back to use it on your allies will end up polluting everything. Then when you go to weld again it would not be enough.
Tidak ada komentar:
Posting Komentar